ATTACK DPX LAMBDA Instrukcja Obsługi Strona 39
- Strona / 51
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
39
Antifreeze protection (warning)
Cause:
Control light 2 yellow:
Correction:
Reset:
Boiler temperature is < 7°C, when the boiler
is switched off
Lights
Do heat-up and burn-out
Automatically with new burn-out (button +),
or when the boiler temperature is > 8°C
Emergency program: Yes, burn-out is possible - do that!
Antifreeze protection
Boiler temperature
(°C)
Actions of regulator: At boiler temperature < 7°C:
Circuiting pump starts
By this action, if there is warmth of the tank,
it is taken off. If there is no warmth in the
tank, the freezing point in circuiting water
decreases.
At boiler temperature > 8°C:
Circuiting pump is switched off
Incorrectly measured values of Oxygene sensor – Lambda probe (error)
Cause:
Control light 2 yellow
Non-apparent heating by means of sensor
error in electric circuit or short circuit
Lights
Correction:
Check sockets and conductors.
Demount and clean oxygene sensor. If it is
necessary, replace it.
Reset:
Emergency program:
Actions of regulator:
Automatically after error removing and
resetting of scale of the oxygene sensor.
Regulator works with alternative air V1 and
V2. After burning-out, the boiler must be
manually switched off by the „-“ button.
Error in measuring
O2
Boiler temperature
(°C)
Not to shorten the boiler´s life-time, it is necessary to remove the
error immediately! Possible expiration of warranty!
Errors, functions and actions of regulator - summary
Errors and functions Actions or operation of the regulator
Power failure When the power is supplied again, the operation state is
regenerated, same as it was before.(boiler starts or stops again)
Too high boiler temperature < 90°C: fan is stopped
> 89°C: fan is switched on
Incorrectly measured values
of boiler temperature
Stop of flue gas fan and connection pump. It is not possible to
turn the boiler on.
Incorrectly measured values
of flue gas
It is possible to turn the boiler on. Regulator works with
alternative air V1 and V2. After burning-out, the boiler must
be switched manually!
Incorrectly measured values
of O2 sensor (Lambda probe)
While heating-up, no line graph is dislayed.It is possible to
turn the boiler on, regulator works with spare air V1 and V2.
Automatic function of switch If the boiler is switched on for 30 minutes and flue gas
- ATTACK DPX 1
- Manual content: 4
- Introduction: 5
- Technical parameters: 6
- Instrument panel 8
- ATTACK DPX PROFI 9
- ATTACK DPX LAMBDA 10
- Purpose of usage 11
- Technical description 11
- Operation prescriptions 11
- Attention 11
- Fuel shortage 14
- Boiler overheating 15
- Error messages 15
- Combustion regulation 16
- Test of device 19
- Safety test 19
- Setting 19
- ATTENTION! 27
- Boiler protection against 28
- Connection schemes 32
- Liquidation of packaging 34
- Accessories 35
- Overheating (warning) 38
- Probe warming 45
- Grounding of covering 46
- Network cord 46
- Producer: 51
Powiązane produkty i podręczniki dla Grzejniki wodne i kotły ATTACK DPX LAMBDA
(16 strony)
(58 strony)De Dietrich FWPC_FWPS_FWS_FWP Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Wasserkocher De Dietrich FWPC_FWPS_FWS_FWP.
Wir stellen 1 PDF-Handbücher De Dietrich FWPC_FWPS_FWS_FWP zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Komentarze do niniejszej Instrukcji